BLUECAST CR3A LCD

Description

Cr3a is one of the easiest castable resins to print and ensure excellent casting. Differently from other monomer based resin that requires complex and tricky treatments our BC Cr3a just requires to be washed after print and cured in to BC CURING LIQUID we supply.

No hot water wash required, no boiling, no overnight curing.

PRODUCT FEATURES

• Consistent casting quality as BlueCast standard
• Ash residual 0.00%proprietary TGA at 750°C / 4 hrs without contact to air, in closed vessel
• Low cost
• Negligible shrinkage
• No primer needed
• Monomer based resin (*)
• High resolution
• Good strength
• Fast printing speed
• Very low odor
• Very low viscosity, no need to heat
• Chromacure® will tell you when postcure is done and pattern is ready to cast

Additional information

Remove the prints from the build plate

Wash the prints in ethyl alcohol 90% to 99%

Dry the patterns with compressed air for best results.

Place the prints in a vessel / plastic cup – Fill the vessel with CREA CURING LIQUID in order to fully submerge patterns

Place the vessel with the patterns inside at UV oven for 30 / 40 min according lamp power and patterns size The UV cure is done when the pattern color will be BLU (ring on the right)
Wash with tapered water and dry with air AND GO TO CAST.

INSTRUCTIONS SHEET